1) SNETP is not installed. Even if communication with the CPU is not made actually, SNETP must be installed. Refer to section 3.1 \"Installation\" to install the SW6RN-SNETP (Ver. 00B or later. If communication is made only with the Q172/Q173CPU, install SW6RN-SNETP.
• A list of applications for communication with the CPU is displayed. The following applications cause the phenomenon described to the left. (Applications other than those listed below operate without SNETP.)
GSV[ ][ ]P : Monitor, communication, program editor, install, mechanical system editor, test, backup, servo data setting (for writing to servo amplifier)
SW6RN-DOSCP: Digital oscilloscope
2) SNETP has been installed but is incompatible with the package given on the left. (SW6RN-SNETP (Ver. 00B or later) has been installed.) Refer to \"3.7 Updating Instructions and Procedures\" and update one set of SW6RNC-GSVE.
3) The PATH specified as the long name has been described in AUTOEXEC.BAT.
*: Long name: Folder name of 9 or more characters
Describe the SNETP PATH before the PATH specified as the long name, and always add \"%PATH%\" before the part where the long name has been specified. It is not required if it has already been described.
(Example)
• Before change SET PATH=\"C:\\ProgramFiles\\ABC;\" (*1) SET PATH=%PATH%;C:\\PROGRA~1\\Sw6Sne~1; (*2)
↓
• After change SET PATH=%PATH%;\"C:\\PROGRA~1\\Sw6Sne~1;\"SET PATH=%PATH%;\"C:\\ProgramFiles\\ABC;\"
*: Always described the (wiggly line) part.
(*1): Long name PATH
(*2): SNETP PATH |
发表于 2012-7-9 11:31:05
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
千斤顶
显身卡
斑竹太好了...